Analysis for microstructure of microlens arrays on micro-injection molding by numerical simulation

Yung Kang Shen, Chih Yuan Chang, Yu Sheng Shen, Sung Chih Hsu, Ming Wei Wu

研究成果: 雜誌貢獻文章同行評審

28 引文 斯高帕斯(Scopus)

摘要

Micro-injection molding is the most important technology in MEMS/NEMS industry for the necessary of scale, velocity and cost by the development of MEMS/NEMS industry and the innovation of MEMS/NEMS industry. It has the advantage of low cost, low interface and small volume in MEMS/NEMS industry. This paper emphasizes the analysis for microstructure of microlens arrays on micro-injection molding. The finite element simulation in a three-dimensional inertia-free, incompressible flow is presented. A control volume scheme with a fixed finite element mesh is employed to predict melt front advancement. The plastic material of microlens arrays is used for PMMA material. The results show the short shot on the filling stage of micro-injection molding. The results also indicate that the melt front first advance into the thickness direction of microlens arrays, and then it goes into the microstructure of microlens arrays.
原文英語
頁(從 - 到)723-727
頁數5
期刊International Communications in Heat and Mass Transfer
35
發行號6
DOIs
出版狀態已發佈 - 7月 2008

ASJC Scopus subject areas

  • 凝聚態物理學
  • 一般化學工程
  • 原子與分子物理與光學

指紋

深入研究「Analysis for microstructure of microlens arrays on micro-injection molding by numerical simulation」主題。共同形成了獨特的指紋。

引用此